How to Apply a Liquid Roof for RV Repair

When your RV is performing like it’s supposed to, it’s your key to practically unlimited freedom. Any location that is attached to yours by road can be traveled to without problem. However, one little leak can mean your travel plans need to be postponed until it’s addressed. Fortunately, a liquid roof for RV repair makes getting back on the road a simple process. While you can pay others to handle the process, handling the repair with EPDM coating isn’t too difficult if you follow the below instructions.

Wait for Good Conditions

When applying liquid roof RV repair products, the one thing you need to careful about is the weather. If your RV is housed under a roof, then all you need to do is make sure the temperature isn’t going to be too far to one end of the thermostat or the other.

If you don’t have a covered area, then just keep an eye on the forecast. You need three straight days without rain or your work is going to be for nothing.

Fix Any Issues Caused by the Leak

Unless you caught it right away, that damage to your RV’s roof probably caused some problems inside too. You’ll want to start, then, by addressing those issues first. If water leaked in and compromised your electronics, you’ll need professional attention as things can otherwise get pretty dangerous.

Otherwise, you most likely just have cleaning to do. Bleach is both affordable and effective here. Mix one part of it with three parts of water and most stains—even stubborn ones—will quickly surrender.

Clean the Roof

Next, clean the roof too. You may already have a product you trust for the job. However, that bleach mixture should work just as well. Be sure to get rid of any debris that may have accumulated on your roof too. When you apply EPDM liquid roof RV repair products, you want a perfectly smooth, clean surface for it to adhere to.

Apply a Coat of Primer

Just like with paint, you’ll want to prime the roof of your RV first. This will make it easier for the liquid roof RV repair product to attach itself to your vehicle. There are a number of products out there to choose from, so just be sure you read the instructions first before beginning.

Roll out the EPDM Product

With the primer taking effect, you can now apply your liquid roof RV repair product. Unless the directions tell you otherwise, begin with an initial coat of about ¾ of an inch. Use a roller to apply it, then let it sit for one to three days. Again, the directions should tell you how long to let it rest for, but checking back on it every day will make it obvious when you can apply another. Put this one down in the opposite direction and you’ll be set.

RV roof repair with an EDM coating doesn’t take expert knowledge of any kind. As you can see, it’s quite simple to do and even very affordable.